Kan iemand zeggen of deze layout identiek is aan die van de Iphone?
Deze is van de Ipod

Pin Signal Description
1
GND
Ground (-), internaly connected with Pin 2 on iPod motherboard
2
GND
Audio & Video ground (-), internaly connected with Pin 2 on iPod motherboard
3
Right
Line Out - R (+) (Audio output, right channel)
4
Left
Line Out - L(+) (Audio output, left channel)
5
Right In
Line In - R (+)
6
Left In
Line In - L (+)
8
Video Out
Composite video output (only when slideshow active on iPod Photo)
9
S-Video Chrominance output
for iPod Color, Photo only
10
S-Video Luminance output
for iPod Color, Photo only
11
GND
Serial GND
12
Tx
ipod sending line, Serial TxD
13
Rx
ipod receiving line, Serial RxD
15
GND
Ground (-), internaly connected with pin 16 on iPod motherboard
16
GND
USB GND (-), internaly connected with pin 15 on iPod motherboard
18
3.3V
3.3V Power (+)
Stepped up to provide +5 VDC to USB on iPod Camera Connector. If iPod is put to sleep while Camera Connector is present, +5 VDC at this pin slowly drains back to 0 VDC.
19,20
+12V
Firewire Power 12 VDC (+)
21
Accessory Indicator/Serial enable
Different resistances indicate accessory type:
1kOhm - iPod docking station, beeps when connected
10kOhm - Takes some iPods into photo import mode
500kOhm - related to serial communication / used to enable serial communications Used in Dension Ice Link Plus car interface
1MOhm - Belkin auto adaptor, iPod shuts down automatically when power disconnected Connecting pin 21 to ground with a 1MOhm resistor does stop the ipod when power (i.e. Firewire-12V) is cut. Looks to be that when this pin is grounded it closes a switch so that on loss of power the Ipod shuts off. Dock has the same Resister.
22
TPA (-)
FireWire Data TPA (-)
23
5 VDC (+)
USB Power 5 VDC (+)
24
TPA (+)
FireWire Data TPA (+)
25
Data (-)
USB Data (-)
26
TPB (-)
FireWire Data TPB (-)
27
Data (+)
USB Data (+)
Pins 25 and 27 may be used in different manner. To force the iPod 5G to charge in any case, when 'USB Power 5 VDC' (pin 23) is fed, 25 must be connected to 5V through a 10kOhm resistor, and 27 must be connected to the Ground (for example: pin 1) with a 10kOhm resistor.
28
TPB (+)
FireWire Data TPB (+)
29,30
GND
FireWire Ground (-)